Grid / DTM

On the Grid / DTM tab, you can:

Generate a Grid Surface
Assign Values to Points Below, Above or Outside of a Grid Surface
Generate Contours and Trend Surfaces from a Grid Surface
Generate Z Values for Points using a Grid Surface
Perform Raster Calculations on a Grid Surface
Convert a Grid Surface to a MM File and vice versa
Convert a Grid Surface to a DTM
Generate a DTM from Strings or Points
Assign Values in a Block Model File to Blocks Below, Above or Outside of a DTM
Assign Values to Points Below, Above or Outside of a DTM
Generate Contours from a DTM
Validate a DTM and Set Validation Options
Calculate Seam Thickness from Roof DTM and a Floor DTM
Calculate Cut and Fill Volumes between DTMs
Trim the Edges of a DTM, or Clip a DTM using Polygons
Generate DTM Boundary Strings
Generate Z Values for Points using a DTM
Convert a DTM to a MM File, a Grid Surface, or a Polyface (DXF) File