Assign Charge Template

On the Charging tab, in the Charging group: Click Assign Templates to assign a charge template to selected drillholes.

(Note: For Ring Design and Development Drilling, you must be in Edit Ring and Edit Round mode, respectively.)

The Selection Assistant will prompt you to select the holes to be assigned a charge template. Right-click or click the Accept button once you have selected the holes:

You will be prompted to select the charge template to assign to the selected holes. A preview of the charge template is shown:

OK

Click OK to assign the selected template to the holes you have selected.

When a charge template is assigned to drillholes, the traces of those holes are updated to show the consumables assigned to the intervals of the hole. The colours selected on the tabs of the Consumables Library are applied.

Note: If the combined length of a charge template’s intervals is greater than the length of the selected hole(s) then the intervals that extend beyond the length of the hole(s) will not be assigned to the hole(s).

Clear

Click Clear to clear the current assignment (if any) for the selected holes.

Note: In Edit Round mode, you can also clear the charge template assigned to the holes of a round, by picking the empty selection from the drop-down control in the Drillholes table:

Edit

Select a charge template from the list and then click on the Edit button to open the Edit Charge Templates form. You can use this option to review and/or modify a template before assigning it to the holes you have selected.

Close

Click Close to close the Assign Charge Template window.