FAQ

Q: Why are my stockpile solids not appearing? A: Check the following:

• Have you set up your process(es) correctly?

• Ensure you have a piece of  set to work the Rehandle process Equipment

• Go to your animation tab and hit Reload Solid

• Check your s in your Settings Prefilter Range

• Reimport your data into your Source table and ensure there are associated volumes

Q: Why isn’t my stockpile filling up? A: Check the Destination paths for your equipment.

Q: Why isn’t my stockpile being dug? A: Check the following:

• Make sure you have successfully prescheduled your stockpile material

• Check that you have correctly included your stockpile material in your Source Path

Q: How do can I continue to dump into/dig my stockpile? A: Ensure that you have “Leave In Paths” selected in your stockpile settings. You must also ‘over-path’ the material you want to dump/dig by adding quantity modifier to your Path. See Step 8.5 for more information.

Q: Why am I getting an error about Stockpile Destination nodes when I run my schedule? A: The error occurs when the Destination Node Expression creates an address which cannot be found in your Destination table. For more information, see Step 7.3.